Home › Plumbing in a 1960s Clayton brick veneer

Guide · Clayton homes

Plumbing in a 1960s Clayton brick veneer

A great many Clayton homes were built in the 1950s and 1960s, and plenty still have original plumbing. Here is what is likely hidden in the walls and under the floor, and what to check first.

Galvanised water pipes

Most homes of this era were plumbed with galvanised steel water pipe. It rusts from the inside, gradually narrowing the bore and eventually leaking. Signs include:

  • Low pressure, especially at the shower
  • Brown or rusty water when a tap is first turned on
  • Pinhole leaks under the house or in walls
  • Rust-coloured stains in basins and toilets

You can often see a section of pipe where it rises from the ground near the meter or under the kitchen sink. Grey, threaded steel pipe is galvanised. Copper is reddish brown, and modern polyethylene is usually black, blue or white.

Clay sewer pipes

The sewer line from the house to the street was typically laid in vitrified clay pipe with mortar joints. Over sixty years, ground movement and tree roots open those joints. Repeated blockages, gurgling drains and an overflowing gully outside are the usual warning signs.

The overflow relief gully

Outside the house, usually near the laundry or bathroom, is a round grate sitting just above ground level. This is the overflow relief gully. If the sewer blocks, sewage should overflow here rather than inside the house. Keep it clear of soil, mulch and pavers, and make sure it sits at least a little above the surrounding ground.

Old hot water systems

Original hot water systems have long gone, but many homes are on their second or third. Check the age and capacity on the label. If it is over ten years old, start planning its replacement before it fails.

Separate toilets and old bathrooms

Many of these homes still have a separate toilet room and an original bathroom. When you renovate, it is a good opportunity to replace the old pipes in the walls and check the sewer on camera before tiling.

What to check first

  1. Look at the pipe near the meter to see what it is made of.
  2. Do a meter test for hidden leaks: turn off all taps and check whether the meter moves.
  3. Watch for slow drains and gurgling.
  4. Check the hot water label for age.
  5. Consider a camera inspection of the sewer if you have had blockages.

Book or get a quote

Tell us about the job

Fill in the basics and a licensed Clayton plumber will ring you back. If water is escaping right now, skip the form and phone 03 9088 4192.

03 9088 4192

Prices are never listed online. We inspect first, then settle the cost with you before a single tool comes out.







    Worth reading

    More guides

    Keeping restaurant kitchen drains flowingPractical drain care for busy cafe and restaurant kitchens around Clayton Road: what blocks commercial drains, staff habits that help and when to schedule jetting.Why is my hot water relief valve dripping?A plain explanation of the relief valve on your hot water system: when dripping is normal, when it is not, and what to do about it.Switching from electric to heat pump hot waterThinking of replacing an old electric hot water cylinder with a heat pump? What to consider in a Clayton home: sizing, placement, solar, noise and rebates.Warning signs of a leaking showerHow to recognise a leaking shower early in a Clayton home or townhouse, what causes it and why it is worth acting before the damage spreads.Shared drains on townhouse sitesHow shared sewer and stormwater drains work on subdivided townhouse sites in Clayton, and how responsibility for blockages and repairs is usually divided.Getting stormwater ready for summer stormsHow to prepare gutters, downpipes and stormwater pits for intense summer thunderstorms in Clayton, and what to do when water pools against the house.Share house plumbing checklist for moving dayA practical plumbing checklist for students moving into a Clayton share house: find the meter, check the hot water, protect the drains and report problems properly.Urgent plumbing repairs in a Victorian rentalA plain guide to urgent plumbing repairs in Victorian rentals: what counts as urgent, what tenants should do, and how costs are usually decided.Tree roots in Clayton sewersWhy tree roots get into older Clayton sewer pipes, the warning signs, and the options from regular clearing to relining.Checking for a leak with your water meterA simple step-by-step check you can do with your water meter to find out whether a hidden leak is pushing up your water bill.

    Plumbing problem in Clayton? Talk to the plumber who will fix it.