Guide · Clayton homes
Checking for a leak with your water meter
A water bill that jumps without explanation often points to a hidden leak. This simple test with your meter takes half an hour and tells you whether water is escaping.
Find your meter
In most Clayton homes the meter is near the front boundary, in a garden bed, against the fence or in a box in the nature strip. On unit and townhouse sites, meters are usually grouped together near the street. Check the unit number to be sure you have the right one.
The test
- Turn off every tap, appliance and irrigation system that uses water. Make sure nobody flushes a toilet or runs a shower.
- Look at the meter. Most have a set of numbers and a small dial or star that spins when water flows.
- Write down the reading or take a photo.
- Wait thirty minutes without using any water.
- Check the meter again.
If the reading has changed or the small dial is moving, water is leaking somewhere.
Narrowing it down
Toilets
Put a few drops of food colouring in each toilet cistern and wait twenty minutes. If colour appears in the bowl, the cistern is leaking.
Taps
Check every tap for drips, including outdoor taps and the laundry.
Hot water relief valve
Look at the drain pipe from the relief valve. A steady drip or flow means water is being lost.
Isolate the house
If you have an isolation valve where the pipe enters the house, close it and check the meter again. If the meter stops, the leak is inside the house. If it keeps moving, the leak is underground between the meter and the house.
What next
If you cannot find the leak, call us. We use thermal imaging, acoustic detection and pressure testing to locate hidden leaks. South East Water may offer a bill allowance for leaks once a licensed plumber has repaired them, so keep our invoice and report.
Book or get a quote
Tell us about the job
Fill in the basics and a licensed Clayton plumber will ring you back. If water is escaping right now, skip the form and phone 03 9088 4192.
Prices are never listed online. We inspect first, then settle the cost with you before a single tool comes out.
Worth reading