Guide · Clayton homes
Keeping restaurant kitchen drains flowing
A blocked floor waste in the middle of dinner service can shut a kitchen down. These habits and maintenance steps keep Clayton Road kitchens running.
What blocks commercial kitchen drains
- Fat, oil and grease that cools and sticks to pipe walls
- Starch from rice, noodles and dumplings
- Food scraps washed off plates and woks
- Coffee grounds in cafes
- Cleaning cloths and scourers that slip down floor wastes
Even with a grease trap, the pipes between the sinks and the trap collect build-up, and that is where most blockages happen.
Staff habits that help
- Scrape plates and woks into the bin before washing.
- Use strainers in every sink and floor waste and empty them often.
- Never pour oil or fat down any drain. Collect it for a licensed waste collector.
- Keep the grease trap lid sealed and the pump-out schedule up to date.
- Report slow drains early rather than waiting for a blockage.
Scheduled jetting
High-pressure jetting scours fat and starch from the inside of the pipes before it can build into a blockage. For busy kitchens, regular jetting every few months, scheduled before opening or after close, is usually cheaper than an emergency call during service.
Grease traps and trade waste
Many food businesses must have a grease trap and a trade waste agreement with South East Water. The trap is pumped out by a licensed liquid waste contractor on a set schedule. We keep the plumbing on either side of the trap clear and can advise on what your trade waste agreement requires of the drainage.
Warning signs
- Floor wastes slow to drain after mopping
- Bad smells from drains
- Gurgling sinks
- Water backing up into the floor waste when the dishwasher empties
If you notice any of these, book a clean before it turns into a blockage during service.
Book or get a quote
Tell us about the job
Fill in the basics and a licensed Clayton plumber will ring you back. If water is escaping right now, skip the form and phone 03 9088 4192.
Prices are never listed online. We inspect first, then settle the cost with you before a single tool comes out.
Worth reading